For reconfiguring a CmDongle, please proceed as follows:ġ. Open a CodeMeter Command Prompt using “Start | All Programs | CodeMeter | Tools | CodeMeter Command Prompt”.Įxecute the following command, replacing the with your CmDongle serial number, e.g. Depending on how your system is configured and interacts with the CmDongle, it might be helpful to change the configuration. devices with a memory of less than 128 MB, can be configured to be detected as a local disk or removable disk. So you need to reconfigure this CmDongle to the HID communication mode if this is possible for the CmDongle.ĬmDongles without real flash memory, i.e. Otherwise please contact Wibu support to learn how to reconfigure your CmDongle before upgrading. If your CmDongle is already configured as HID, nothing has to be changed. If you use a CmDongle, it is recommended to check the communication mode prior to upgrading. The Problem is that the CmDongles are configured as massStorage Devices.īecause of Changes in the MacOS handling of Kernel Extensions_Īs of version 7.10, CodeMeter Runtime no longer contains a Kernel Extension (kext). Select Full Disk Access, and then check “CodeMeter” ON to resolve this issue. If your CmStick is no longer showing up in the CodeMeter Control Center after upgrading your OS, then in macOS Preferences/Privacy&Security, Privacy tab… If on a domain, and in a domain admin group, make sure the particular system is granting system admin status to domain admin group.Make sure you have top level system admin access to the computer.-Remove the CodeMeter CmStick from your USB port.If your stick or license seem to be correct and your software still isn’t launching and your still getting a Codemeter error then follow the below steps for the best practices to re-install the Codemeter runtime.I can’t tell you how many times I have been emailed about a 300 error when the user purchased only version 2.x and never upgraded to 3.x….8) Make sure you installed the correct software version for the license you have on your CmStick.Note: a 300 license is for 3.x and a 200 license is for BaseHead 2.x and 400,410 and 420 are for 4.x and 500-530 are for 5.x etc…. Next….click the WebAdmin button and go to Content/.Licenses.See the bottom of this page for how to do a proper un-install re-install of the CM Runtime with links.

2nd, do you have the most recent CodeMeter Runtime Installed?.Press the hooked arrow to update the firmware. If so….make sure you have the most recent firmware.

Codemeter webadmin not working